Check out our list of seven essential types of campfires and find out how and when to use them.

1. Tensile strength

This type of design is ideal for windy days. First, find a medium-sized log and place it where you want to start a fire. The hull must be horizontal and oriented towards the wind.

It is used to stop the wind and maintain the fire.

photo by Ilya Hitt on Unsplash

Then you need a bundle, usually a bundle of fibers bound together. You could use dead grass or weeds. Or use dead, dry plants, as they are adapted to convert sparks into fire.

Then take the coil and place it in front of the tree trunk, where the wind cannot reach. It should also be placed horizontally, as well as the way the trunk is placed.

The last thing you need to put down are the twigs (the kindling). They should be supported against the hull, above the gables you have placed. The branches should be placed vertically as they rest on the trunk.

When you’re ready to light it, take your lit match and place it on one end of the coil. The fire must be lit and get going.

for

  • That’s easy to do.
  • Great against the wind
  • Big rain versus little rain

Other

2. Log cabin fire

This type of fire is not possible for everyone, as conifers must be cut with an axe. This requires many large and medium-sized conifers.

First, cut the conifers and start building a diamond shape on the ground. So you have two parallel parts at the bottom and two parallel parts at the top, but facing east and west.

This will be the first layer.

Next, you need to build a platform with a smaller link in the middle of your form. Load the middle of a layer, and when it’s done, you can put the larger conifers on top with the same diamond shape as before.

This will give your fabric enough oxygen to start and maintain the growth of the flame, being a layer above the ground.

After another three layers of softwood, birch can be added. This also allows the fire to be lit.

You will also need to add a small amount of kindling, enough to fill the three layers you made earlier.

Finally, add a few pieces of conifers and you’re ready to light the fire!

To start the fire, use a lit match and reach for the birch bark. When the air is filled with all the layers you made, the birch should immediately start a fire.

http://server.digimetriq.com/wp-content/uploads/2021/01/1611047858_114_7-Types-Of-Campfires-And-How-To-Use-Them.jpg Image by BitBot-Media from Pixabay

for

  • Generates a lot of heat
  • Ideal for the kitchen
  • Low operating costs
  • For a long time.

Other

  • It takes time to build
  • It’s harder to maintain a fire when it’s windy.

3. Campfire in cabin

This is probably the most common campfire of all time. It’s much easier and faster.

You must first form a layer of 6 to 7 sticks on the floor. This lets air in and ensures that the fire starts without any problems.

Then you must place the gilding directly on the layer created. It’s the tinder that lights up first.

Then take four pieces of wood, push them into the ground and blow out each top. On each side of the layer of the binding roll, a piece of wood should be tied like a triangle.

Campfire in a teepee Photo by Thomas Despeyroux on Unsplash

Then you have to start filling the circle with kindling until there is no more room. Continue to dig each piece into the ground, making sure the top ends in the middle.

If you have more firewood or oversized firewood, you can add it to your complete teepee.

A small section must be left open for the fire to enter and ignite.

for

  • Generates a lot of heat
  • That’s easy to do.
  • Good for the kitchen

Other

  • No maintenance required
  • It’s hard to rise in the wind…

4. Starfire

This is a very traditional burn pattern that has been around for a long time. The good thing about this type of fire is that it can last a long time, it’s incredible when you start filling an established fire.

The key is to dig a small area where your fire will be. It doesn’t have to be a big hole, because it gives more oxygen to the fire.

Then take the balm and put it in the little hole you made.

Then take about eight logs and place them in a star shape. To do this, take a log, lay it down and place the next log diagonally next to it. The advice should be moving. Continue like this until you get to the first paper.

The logs should be about two meters long.

Finally, take a few small sticks to form a platform in the middle of your newspaper. This will be your ignition, so make sure they are connected properly.

You can remove one of the magazines and turn on a reflector to monitor the fire. Once the fire is properly built, you can add logs to increase the heat and flames. You can also reduce the fire and heat by removing the logs.

for

  • Large cooking surface

Other

  • Subject to wind
  • Maintenance required

5. Platform Campfire

This campfire is popularly known as an inverted campfire.

If you want the fire to last for hours, this is it. If you follow these steps in order, you will have a fire that can burn for about six hours.

You have to pick up four or five large pieces of wood and line them up. Then you have to pick up the dirt or even mud and spread it over the magazines you install.

This step is crucial to ensure that the fire is the last, as the earth does not drop embers on the ground. This slows down the fire and makes it take longer because it has to go through the earth you have set up.

For the next layer, place another set of tens perpendicular to the first set of tens. You have to keep going like this for three more coats. Be sure to cover the dirt between the logs for each layer.

You can then add your shell and smaller stems to the top of your platform. Now light a fire and watch your campfire burn for hours.

PlatformFirePhoto on sarin g on Unspspash

for

  • The fire’s been burning for about six hours.
  • Low operating costs
  • Perfect for the kitchen
  • Lots of heat.

Other

  • The time of assembly and cutting of the logs

6. Dakota Firehole

If you need to hide or conceal a campfire, a campfire site in Dakota is the answer.

You need a shovel to make the fire hole. You dig a hole two feet deep where you want to light a fire. The more you want your fire, the deeper the hole should be. You can also widen it to get a bigger flame.

You then have to make another hole about a foot away from the one you just made. The second hole should be slightly smaller than the first, about 1.5 m deep.

The purpose of the second hole is to supply the flame with oxygen. If you feel your fire needs more oxygen once it’s lit, you can blow gently into the second hole yourself when the flame is on the other side.

Once you have two holes, you can use your shovel to connect the two holes. Make sure the bottom of the hole is well dug and proceed to the other hole. You don’t want everything to fall apart and you have to start over.

For the first hole you made, make a small stick-shaped platform at the bottom. You can then get a group of sticks the same length as the hole and place them there. You have to fill the gap as best you can.

http://server.digimetriq.com/wp-content/uploads/2021/01/1611047862_884_7-Types-Of-Campfires-And-How-To-Use-Them.jpg photo by Manny Moreno on Unsplash

for

  • Perfect for the kitchen
  • Hidden
  • Low operating costs
  • Lots of heat.

Other

7. Swedish missile

It is one of the easiest fires to make. It takes no time and can be used while cooking. You need to find a short log and cut it into four equal pieces.

Then you need some kind of shock. Leave the trunk standing and tie it with small spaces between the pieces. You can fill the voids with different kinds of reeds – wood chips, tree bark or hay.

The last thing you need to do is light the bowl and watch the fire start. You can continue to add small pieces of firewood as the fire begins to grow.

This fire is ideal for boiling water to cook a variety of foods that need to be cooked. You can put the pot directly on that fire once the fire has burned the ashes on it.

for

  • Good for the kitchen
  • That’s easy to do.
  • Portable location

Other

  • You need tools.
  • The fire doesn’t last long.

This article is part of our comprehensive Firefighting Tips for Campers guide.

Dim:

How to load…

Partner

types of campfires and their uses pdftypes of fire in scoutingswedish fireteepee firebest type of campfirelog cabin firedifferent types of cooking firesplatform campfire

You May Also Like

How To Calculate Ah (Amp hours) and Wh (Watt hours) of a Battery Bank

For this example, I will use my own bank of stand-alone batteries…

Best .300 Blackout Suppressors: Top 4 Expert Picks

The .300 AAC Blackout has been a popular rifle cartridge since its…

Night-time Navigation: Top 8 Tips

Night navigation makes its way through the night landscape. Even though it…

Best Geiger Counter For Preppers

Geiger counter / radiation detector. The drafters are concerned about the possibility…